標準簡介：This standard specifies the hole-drilling test method for measuring residual stresses near the surface of an isotropic liner-elastic material, which also covered measuring equipment, measuring procedures, the calibration of the stress calculation constant, the correction of the measurement error and so on. Hole-drilling method is applicable to measure the stress state of the metal material where the internal stress gradient is small, the residual stress of this state which is almost a constant (uniform stress) may not change along the depth direction.Whereas the hole-drilling method can only determine the residual stresses of the material near the surface, so the hole-drilling method only can measure the local residual stresses in the boundary of the hole.

標準號：GB/T 31310-2014E

標準名稱：金屬材料 殘余應力測定 鉆孔應變法（英文版）

英文名稱：Metallic Materials—Residual Stress Determination—Hole-Drilling Strain-Gage Method

標準類型：國家標準

標準性質：推薦性

標準狀態：現行

發布日期：2014-12-05

實施日期：2015-09-01

中國標準分類號（CCS）：冶金>>金屬理化性能試驗方法>>H22金屬力學性能試驗方法

國際標準分類號（ICS）：冶金>>金屬材料試驗>>77.040.10金屬材料力學試驗

歸口單位：SAC/TC 183 Technical Committee o

發布單位：General Ad.